Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Install 2 new copper brake hose gaskets.

Assemble the 2 new copper brake hose gaskets and the brake hose bolt to the brake hose.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the brake hose to caliper bolt and 2 new washers to the brake caliper.
Tighten: Tighten the bolt to 40 N.m (30 lb ft).

Fig 1: View Of Brake Hose To Caliper - Rear

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The hose must not be twisted. Make sure the hose is not in contact with any suspension component.

Install the brake hose (1) into the brake hose bracket.
Install the brake hose retaining clip (3).
Remove the rubber cap or plug from the exposed brake pipe fitting end.
Connect the brake pipe fitting nut (2) to the brake hose (1):
- Use a backup wrench on the hose fitting (1).
- Do not bend the bracket or the pipe.
  Tighten: Tighten the brake pipe fitting end (2) to 25 N.m (18 lb ft).

Fig 2: Installing Brake Hose, Brake Pipe Fitting & Retaining Clip - Rear

Courtesy of GENERAL MOTORS CORP.

Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Ensure that the hose does not make contact with any part of the suspension or the wheel. If the hose makes contact remove the hose and correct the condition.
Lower the vehicle.