LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1014 (Hydraulic Brake System) >> Repair Instructions >> Brake Assist Pump Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the vacuum hose from the brake assist pump.
  2. Disconnect the electrical connector.
  3. Remove the brake assist pump nuts.
  4. Remove the brake assist pump from the booster by pulling the inlet tube out of the grommet.
    5. Fig 1: Removing Brake Assist Pump & Nuts
    GM888257Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals