LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1014 (Hydraulic Brake System) >> Repair Instructions >> Brake Assist Pump Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake assist pump to the booster by pushing the inlet tube into the grommet and aligning the studs to the holes.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake assist pump nuts.

    Tighten:  Tighten the nuts to 18N.m (13 lb ft).

    3. Fig 1: Installing Brake Assist Pump & Nuts
    GM888257Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector.
  4. Install the vacuum hose to the brake assist pump.
scientia non olet · About LEMON Manuals