LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Front Drive Axle) >> Repair Instructions >> Vent Hose Connector Replacement - Front Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the vent hose connector into the differential carrier assembly.

    Apply a small amount of sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent onto the threads.

    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Tighten the vent hose connector.

    Tighten:  Tighten the vent hose connector to 28 N.m (21 lb ft).

    3. Fig 1: View Of Vent Hose Connector
    GM847064Courtesy of GENERAL MOTORS CORP.
  3. Connect the vent hose to the vent hose connector.
    4. Fig 2: View Of Vent Hose To Differential Carrier Assembly
    GM834272Courtesy of GENERAL MOTORS CORP.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals