Pinion and Ring Gear Inspection
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- The ring and pinion gears are matched sets and must be replaced any time a replacement of either is necessary.
- Inspect the pinion and the ring gear teeth for the following conditions:
- Cracking
- Chipping
- Scoring
- Excessive wear
- Inspect the pinion gear splines for wear.
- Inspect the pinion flange splines for wear.
- Inspect the fit of the pinion flange on the pinion gear.
- Inspect the sealing surface of the pinion flange for nicks, burrs, or rough tool marks which will damage the inside diameter of the pinion seal and result in an oil leak.
- Inspect all of the parts for wear and replace as necessary.