Lubricant Level Inspection - Front Drive Axle
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Make sure the vehicle is level.
- Inspect the front axle for leaks. Repair as necessary.
- Clean the area around the front axle fill plug.
- Remove the front axle fill plug (1).
- Inspect the oil level.
Specification:
- For the 8.25 inch axle, the oil level should be between 12-16 mm (0.50-0.625 in) below the fill plug opening.
- For the 9.25 inch axle, the oil level should be between 0-6 mm (0-0.25 in) below the fill plug opening.
- If the level is low, add oil until the level is between 12-16 mm (0.50-0.625 in) for the 8.25 inch axle or 0-6 mm (0-0.25 in) for the 9.25 inch axle. Use the correct fluid. Refer to Sealers, Adhesives, and Lubricants .
- Install the fill plug.
Tighten: Tighten the plug to 33 N.m (24 lb ft).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.