LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Front Drive Axle) >> Repair Instructions >> Electric Motor Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply sealant to the threads of the electric motor actuator. Use the correct sealant. Refer to Sealers, Adhesives, and Lubricants .
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the electric motor actuator (3).

    Tighten:  Tighten the actuator to 20 N.m (15 lb ft).

    3. Fig 1: Electric Motor Actuator
    GM339436Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the actuator.
  4. Install the front differential carrier shield, if equipped. Refer to Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals