LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier assembly. Refer to Differential Carrier Assembly Replacement .
  2. Remove the upper differential carrier assembly bushing by performing the following steps:
    1. Install the J 36616-2 (1), the J 33791-1 (2), the thrust bearing (3), the J 21474-18 (4), and the forcing screw as shown.
    2. Remove the upper differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
    3. Fig 1: Remove The Upper Differential Carrier Assembly Bushing Using J 36616-2, J 33791-1, Thrust Bearing, J 21474-18 & Forcing Screw
    GM893247Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower differential carrier assembly bushing by performing the following steps:
    1. Install the J 21474-18 (1), the thrust bearing (2), the J 33791-1 (3), the J 36616-2 (4), and the forcing screw as shown.
    2. Remove the lower differential carrier assembly bushing by holding the forcing screw and slowly tightening the J 21474-18.
    4. Fig 2: Removing The Lower Differential Carrier Assembly Bushingj 21474-18, Thrust Bearing, J 33791-1, J 36616-2, & Forcing Screw
    GM892847Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals