LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Front Drive Axle) >> Repair Instructions >> Clutch Shaft Bearing Replacement - Front Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the bearing with axle lubricant. Use the proper fluid. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication.
  2. Install the clutch shaft pilot bearing using the J 33842  .
    3. Fig 1: Installing Clutch Shaft Pilot Bearing - Front Drive Axle
    GM695745Courtesy of GENERAL MOTORS CORP.
  3. Install the clutch shaft to the differential carrier assembly.
  4. Install the inner axle shaft and housing assembly. Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle (8.25 S4WD and 9.25 Axles)  or Inner Shaft and/or Housing Replacement - Front Drive Axle (8.25 F4WD Axle) .
scientia non olet · About LEMON Manuals