Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the cushions (1) as necessary and raise the chassis accordingly.

Fig 1: Installing Frame Cushion (Extended Cab)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the body mount bolts.
Tighten: Tighten the bolts to 85 N.m (63 lb ft).
Install the park brake equalizer intermediate cable. Perform the following steps:
1. Pull rearward on the park brake cable to the original position.
2. Secure the cable retaining tabs to the frame.
3. Install the intermediate cable end to the equalizer.
4. Install the nut to the threaded end of the intermediate cable.
  Tighten: Tighten the nut to 4 N.m (31 lb in).
Lower the vehicle.
Install the master cylinder. Perform the following steps:
1. Mount the master cylinder to the brake booster.
2. Install the master cylinder mounting nuts.
  Tighten: Tighten the nuts to 36 N.m (27 lb ft).