LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1012 (Frame & Underbody) >> Repair Instructions >> Damaged Cage Nut Service >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Remove the battery ground (negative) cable.
  2. Remove the frame bolt (2) from the frame crossmember nut.
    3. Fig 1: Removing Frame Bolt
    GM307714Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The frame crossmember nut retainer will be reused if not damaged from the stripped out bolt.
  3. Break away the spot welds (1) on one side of the frame crossmember nut retainer with an air chisel.
  4. Lift one side of the frame crossmember nut retainer (enough to remove the frame crossmember nut).
  5. Remove the frame crossmember nut.
    6. Fig 2: Frame Crossmember Nut
    GM307715Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals