Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine crossmember.

Fig 1: Installing Engine Crossmember (2WD)

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 2: Installing Engine Crossmember Bolts (2WD)

Courtesy of GENERAL MOTORS CORP.

Install the engine crossmember bolts.
Tighten: Tighten the engine crossmember bolts to 120 N.m (88 lb ft).
Lower the vehicle.