LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1012 (Frame & Underbody) >> Repair Instructions >> Assist Step Replacement (Body Mount) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following components from the vehicle:
    1. The center body mount bolt (1)
    2. The lock washer
    3. The washer
  2. Remove the center lower body-cushion assemblies (4).
  3. Remove the following components from the assist step:
    1. The center bolt (2)
    2. The lock washer
    3. The washer
  4. Remove the assist step center bracket (5).
    5. Fig 1: Removing Assist Step
    GM768787Courtesy of GENERAL MOTORS CORP.
  5. With an assistant, remove the following front components, and rear components:
    1. The body mount bolts (1)
    2. The lock washers (2)
    3. The washers (3)
  6. With an assistant, remove the assist step assembly from the vehicle.
  7. Remove the lower body-mount cushion assemblies (4), front and rear, from the vehicle.
    8. Fig 2: Removing Lower Body-Mount Cushion Assemblies
    GM768798Courtesy of GENERAL MOTORS CORP.
  8. Remove the following components from the front assist step brackets, and from the rear assist step brackets:
    1. The bolts (1)
    2. The lock washers (2)
    3. The washers (3)
  9. Remove the front brackets, and the rear brackets (4) from the assist step.
  10. Remove the front gaskets, and the rear gaskets (5) from the assist step.
    11. Fig 3: Removing Assist Step Components
    GM768801Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals