LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Engine Control System Self-Diagnostics - 3.4L) >> Diagnostic Tests >> DTC P0103: MAF Sensor Circuit - High Frequency >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, 2002 Chevrolet Monte Carlo, and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
  2. Observe the Freeze Frame/Failure Records data for this DTC. Turn ignition off for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC or as close to the Freeze Frame/Failure Records data that you observed. See CONDITIONS FOR RUNNING DTC . Does the DTC fail this ignition? If yes, go to next step. If no, see DIAGNOSTIC AIDS .
  3. Turn ignition off. Disconnect the harness connector of the MAF sensor. Start the engine. Observe the MAF sensor frequency with a scan tool. Does the scan tool display 0 Hz? If yes, go to step  5. If no, go to next step.
  4. Inspect the harness of the MAF sensor for incorrect routing that is too close to the secondary ignition wires or coils, any solenoids, relays or motors. Did you find and correct the condition? If yes, go to step  9. If no, go to step.  6.
  5. Test for an intermittent and for a poor connection at the MAF sensor. Did you find and correct the condition? If yes, go to step  9. If no, go to step  7.
  6. Test for an intermittent and for a poor connection at the PCM. Did you find and correct the condition? If yes, go to step  9. If no, go to step  8.
  7. Replace MAF sensor. After replacing sensor, go to step  9.
  8. Turn ignition off. Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE  under PROGRAMMING. After replacing PCM, go to next step.
  9. Use the scan tool in order to clear the DTCs. Turn ignition off for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step  2.
  10. With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals