LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1009 (Wiper System & Washer System) >> Repair Instructions >> Wiper Motor Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition key to the OFF position.
  2. Open the hood.
  3. Remove the radio antenna. Refer to Fixed Antenna Replacement in Entertainment.
  4. Remove the wiper arms. Refer to Wiper Arm Replacement .
  5. Remove the air inlet panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  6. Remove the connector position assurance (CPA) connector (1).
  7. Disconnect the electrical connector (2) from the wiper motor cover (4).
  8. Remove the 4 screws (3) that secure the cover to the motor.
  9. Remove the cover (4) from the vehicle.
    10. Fig 1: CPA Connector Electrical Connector, Motor Cover & Screws
    GM1510196Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals