LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1009 (Wiper System & Washer System) >> Diagnostic Information and Procedures >> Washers Always On

Washers Always On

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Washers Always On

Step Action Yes No
Schematic Reference: Wiper/Washer System Schematics 
Connector End View Reference:  Wiper/Washer System Connector End Views  
DEFINITION: The windshield washer pump is always on.
1 Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? Go to Step 2  Go to Symptoms - Wiper/Washer Systems 
2
  1. Turn the windshield wiper/washer switch to the OFF position.
  2. Turn the ignition ON, with the engine OFF.
Is the windshield washer pump always ON?
Go to Step 3  Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3 Are the windshield wipers always ON, also? Go to Step 4  Go to Step 6 
4
  1. Turn the ignition OFF.
  2. Disconnect the windshield wiper motor module connector.
  3. Turn the ignition ON, with the engine OFF.
  4. Connect a test lamp from the windshield wiper switch signal circuit terminal to ground.
Does the test lamp illuminate?
Go to Step 5  Go to Step 12 
5 Test the windshield wiper switch signal circuit for a short to voltage. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 16  Go to Step 10 
6
  1. Turn the ignition OFF.
  2. Disconnect the windshield washer relay.
  3. Turn the ignition ON, with the engine OFF.
Is the windshield washer pump ON?
Go to Step 8  Go to Step 7 
7 Connect a test lamp from battery positive voltage to the windshield washer relay control circuit terminal in the underhood fuse block.
Does the test lamp illuminate?
Go to Step 9  Go to Step 14 
8 Repair the windshield washer pump control circuit for a short to voltage. Refer to Wiring Repairs in Wiring Systems.
Is the repair complete?
Go to Step 16  -
9 Test the windshield washer relay control circuit for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 16  Go to Step 12 
10 Inspect for poor connections at the windshield wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 16  Go to Step 11 
11 Replace the windshield wiper/washer switch. Refer to Multifunction, Turn Signal Switch Replacement in Steering Wheel and Column.
Did you complete the replacement?
Go to Step 16  -
12 Inspect for poor connections at the windshield wiper motor module. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 16  Go to Step 13 
13 Replace the windshield wiper motor module. Refer to Wiper Motor Replacement .
Did you complete the replacement?
Go to Step 16  -
14 Inspect for poor connections at the windshield washer relay. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 16  Go to Step 15 
15 Replace the windshield washer relay.
Did you complete the replacement?
Go to Step 16  -
16 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3