LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1008 (Heating, Ventilation And Air Conditioning - Gas) >> Repair Instructions >> Blower Motor Replacement (Delphi) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Blower Motor (Delphi)
    GM382496Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor.
    2. Fig 2: Turning Blower Assembly Clockwise (Delphi)
    GM382498Courtesy of GENERAL MOTORS CORP.
  2. Install the blower motor to the heater/ventilation module. Turn the blower assembly clockwise until the retaining tab locks into place.
  3. Install the blower motor insulating cover.
    4. Fig 3: View Of Electrical Connector At The Blower Motor
    GM476821Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the blower motor.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the blower motor insulating cover screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  6. If equipped, install the sound insulator panel. Refer to Insulator Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals