LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1007 (Automatic Transmission - 4L80-E/4L85-E (Introduction, Service & Replacement)) >> Repair Instructions >> Vent Hose >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the vent hose to the transmission.
  2. Install the vent hose to the clip.
    Fig 1: Installing The Vent Hose
    GM765125Courtesy of GENERAL MOTORS CORP.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt and the clamp.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals