LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1007 (Automatic Transmission - 4L80-E/4L85-E (Introduction, Service & Replacement)) >> Repair Instructions >> Output Shaft Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the output speed sensor seal with automatic transmission fluid.
  2. Install the output speed sensor (2).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Input & Output Speed Sensors
    GM686957Courtesy of GENERAL MOTORS CORP.
  3. Install the output speed sensor bolt.

    Tighten:  Tighten the bolt to 11 N.m (96 lb in).

  4. Connect the output speed sensor (2) electrical connector.
    Fig 2: Connecting The Output Speed Sensor Electrical Connector
    GM859361Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals