LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Molding Replacement - Front Bumper Cap >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Remove the upper air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
  3. Remove the front grille. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
  4. Remove the front bumper. Refer to Bumper Replacement - Front (Old Style)  .
  5. Remove the front bumper fascia cap by depressing all the tabs and pulling up.
    6. Fig 1: Removing Front Bumper Fascia
    GM1326844Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals