LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Molding Replacement - Front Bumper Cap >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the fascia cap tabs to the slots in the bumper.
  2. Install the front bumper cap to the bumper pressing into place until fully seated.
    3. Fig 1: Installing Front Bumper Cap
    GM1326845Courtesy of GENERAL MOTORS CORP.
  3. Install the front bumper. Refer to Bumper Replacement - Front (Old Style)  .
  4. Install the front grille. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
  5. Install the upper air baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper in Engine Cooling.
  6. Close the hood.
scientia non olet · About LEMON Manuals