LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper (SS) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the step pad.
  2. Disconnect the license plate lamp harness.
  3. Raise and support the vehicle with suitable safety stands. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the push-pin retainers from the underside of the fascia.
  5. Remove the fascia from the impact bar.
    6. Fig 1: Removing Fascia Impact Bar & Push-Pin Retainers
    GM1228407Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals