LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Fascia Replacement - Rear Bumper (SS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the locator pin of the fascia to the hole in the impact bar.
  2. Press the push-pin retainers into the underside of the fascia.
    3. Fig 1: Installing Fascia Impact Bar & Push-Pin Retainers
    GM1228407Courtesy of GENERAL MOTORS CORP.
  3. Remove the safety stands, and lower the vehicle.
  4. Connect the license plate lamp harness.
  5. Install the step pad.
scientia non olet · About LEMON Manuals