LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Fascia Replacement - Front Bumper (SS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the center lower grille (1).
  2. Fig 1: Installing Center Lower Grille
    GM1218482Courtesy of GENERAL MOTORS CORP.
  3. Install the air inlet grille panels.
  4. Fig 2: Installing Air Inlet Grill Panels
    GM1228392Courtesy of GENERAL MOTORS CORP.
  5. Warm the bumper surface with the J 25070  152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
  6. IMPORTANT: Do not touch the adhesive backing of the bumper.
  7. Remove the backing from the front end of the bumper.
  8. Press the fascia to the bumper surface while continuing to remove the backing.
  9. Hand roll the fascia to the bumper to ensure proper adhesion.
  10. Fig 3: Installing Fascia To Bumper
    GM1228293Courtesy of GENERAL MOTORS CORP.
  11. Inspect the fascia for bonding.
  12. Install the fascia to the bumper.
  13. Install the 2 push-pins to the top of the fascia.
  14. Fig 4: Installing Fascia Top Push-Pins
    GM1228301Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  15. Install the 4 bolts (1) into the side support bracket.

    Tighten:  Tighten the bolts to 2.8 N.m (25 lb in).

  16. Fig 5: Installing Side Support Bracket Bolts
    GM1228298Courtesy of GENERAL MOTORS CORP.
  17. Install the bumper. Refer to Bumper Replacement - Front (Old Style)  .
  18. Install the grille. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
  19. Close the hood.