LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Bumper Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the license plate lamp harness.
    2. Fig 1: Disconnecting License Plate Lamp Harness
    GM406215Courtesy of GENERAL MOTORS CORP.
  2. Remove the impact bar nut (1).
  3. Remove the plate nuts (2).
  4. Remove the lower frame rail to bracket bolt (3).
  5. Remove the side frame rail to bracket bolt (4).
    6. Fig 2: Removing Lower & Side Frame Rail To Bracket Bolts, Plate Nuts & Impact Bar Nut
    GM379246Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear trailer hitch to bumper bolts (1), if equipped.
  7. Remove the rear bumper from the vehicle.
    8. Fig 3: Removing Rear Bumper
    GM393110Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals