LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Bumper Filler Replacement - Front Side (Old Style) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front grille. Refer to Grille Replacement (GMC) or Grille Replacement (Chevrolet) in Exterior Trim.
  2. Disconnect the electrical connector from the fog lamps, if equipped.
    3. Fig 1: Disconnecting Fog Lamp Electrical Connector
    GM373577Courtesy of GENERAL MOTORS CORP.
  3. Remove the retaining bolts (1, 2) from the front bumper.
  4. Remove the brace bolt (3) from the front bumper.
    5. Fig 2: Removing Front Bumper Retaining & Brace Bolts
    GM379248Courtesy of GENERAL MOTORS CORP.
  5. Remove the front bumper assembly from the vehicle.
  6. Remove the air deflector from the bumper if necessary. Refer to Air Deflector Replacement - Front Bumper Fascia  .
  7. Remove the fog lamps, if equipped. Refer to Fog Lamp Replacement - Front in Lighting Systems.
  8. Remove the S clip securing the bumper filler panel to the wheelhouse splash shield.
  9. Remove the fastener securing the filler panel to the radiator support.
  10. Remove the fastener securing the filler panel to the headlamp bracket.
  11. Remove the bumper filler from the vehicle.
    Fig 3: Removing Bumper Filler Panel
    GM869920Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals