LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1006 (Bumper System) >> Repair Instructions >> Bracket Replacement - Front Bumper (2500)

Bracket Replacement - Front Bumper (2500)

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove all related panels and components.
  2. Remove the damaged bumper bracket.
  3. Visually inspect the frame and restore all damage to factory specifications using 3-dimensional measuring.
    4. IMPORTANT: If the vehicle is equipped with tow hooks, discard original fasteners.
  4. Align the replacement bracket lower bolt holes with tow hook mounting locations and install the bolts (1) supplied.
    5. Fig 1: Tow Hook Mounting Locations
    GM671498Courtesy of GENERAL MOTORS CORP.
  5. Align the front edge of bracket with front edge of frame and mark upper bolt locations (1) on frame.
    6. Fig 2: Bracket Upper Bolt Locations
    GM671426Courtesy of GENERAL MOTORS CORP.
  6. Rotate the bracket forward and drill 13 mm (1/2 in) holes in frame at upper bolt locations.
    7. Fig 3: Drilling Upper Bolt Location Holes In Frame
    GM671416Courtesy of GENERAL MOTORS CORP.
  7. Rotate the bracket back into position.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the fasteners supplied.

    Tighten:  Tighten the torque bracket fasteners to 70 N.m (52 lb ft).

    9. Fig 4: Installing Bracket
    GM671509Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals