LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1005 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (SS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the molding. Ensure that the inner side lip of the molding is seated along the length of the retainer.
  2. Install the 7 push-pins.
    Fig 1: Installing Rocker Panel Molding (SS)
    GM1228443Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals