LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1005 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Fender Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the area where the replacement molding is to be mounted. Use a suitable solvent such as flash naphtha or a mixture of 50 percent isopropyl alcohol and 50 percent water.
  2. Dry the area thoroughly.
  3. Warm the body panel to a temperature range of 16-41°C (60-105°F) with a heat lamp or J 25070  .
  4. Peel off the adhesive tape protective lining.
  5. Align push-pin holes with holes in bracket.
  6. Press on the top part of the molding so that the tape adheres to the body panel.
  7. Install the rocker panel. Refer to Molding Replacement - Rocker Panel (SS) .
  8. Install the push-pin
    9. NOTE: Refer to Fastener Notice in Cautions and Notices.
  9. Install the 3 screws.

    Tighten:  Tighten the screws to 1.9 N.m (16.8 lb in).

    10. Fig 1: Installing Front Fender Rear Molding Screws & Push-In
    GM1228397Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals