LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1005 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Front Door Body Side (SS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the area where the replacement molding is to be mounted. Use a suitable solvent such as flash naphtha or a mixture of 50 percent isopropyl alcohol and 50 percent water.
  2. Dry the area thoroughly.
  3. Warm the body panel to a temperature range of 16-41°C (60-105°F) with a heat lamp or J 25070  .
  4. Peel off the adhesive tape protective lining.
  5. Align push-pin holes with holes in bracket.
  6. Press on the top part of the molding so that the tape adheres to the body panel.
  7. Install the 4 push-pins.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the 2 screws.

    Tighten:  Tighten the screws to 1.9 N.m (16.8 lb in).

    9. Fig 1: Installing Front Door Body Side Molding Screws & Push-Pins (SS)
    GM1228405Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals