LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1005 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Endgate Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the painted surface of the end gate in the tape contact area is clean and dry.
  2. Ensure all rear end spoiler nuts (4) are in place. If necessary, replace the rear end spoiler nut.
  3. Peel the backing from the adhesive on the rear end spoiler.
  4. Lower the front edge of the rear end spoiler (1) against the endgate (3) surface approximately 2 mm (0.08 in) above the endgate offset.
    5. IMPORTANT: Do not let the tape surface contact the endgate surface until after part rotation.
  5. Rotate the rear end spoiler (1) down over the top of the endgate (3).
  6. Press the rear end spoiler (1) to the endgate (3).
  7. Hand roll the rear end spoiler to the endgate in order to ensure proper adhesion.
    8. NOTE: Refer to Fastener Notice in Cautions and Notices.
  8. Install the fasteners (2) securing the rear end spoiler (1) to the endgate (3).

    Tighten:  Tighten the bolt to 2.0 N.m (17 lb in).

    9. Fig 1: Installing Endgate Upper Molding
    GM1336080Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals