Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- If the location of the emblem/nameplate has not been marked apply tape.
- Use the following dimensions in order to mark the proper position of the emblem/nameplate on the end gate.
- 55 mm (2.2 in) (A) From the vertical edge
- 43 mm (1.7 in) (B) From the horizontal edge
- Warm the end gate surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
- Apply tape over the outer surface of the emblem/nameplate to ensure alignment.
- Remove the backing from the front end of the emblem/nameplate.
- Press the emblem/nameplate to the end gate panel surface while continuing to remove the backing.
- Hand roll the emblem/nameplate to the end gate panel to ensure proper adhesion.
- Inspect the emblem/nameplate for bonding.
- Remove the tape from the emblem/nameplate and the area around the end gate emblem/nameplate.
IMPORTANT:
Do not touch the adhesive backing of the emblem/nameplate.