LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1004 (Parking Brake System) >> Repair Instructions >> Park Brake Release Handle Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
  2. Remove the park brake release lever mounting bolt.
  3. Remove the park brake release lever handle from the knee bolster.
  4. Remove the MID-bussed electrical center from the bracket.
  5. Remove the park brake release cable housing from the pedal assembly.
  6. Remove the park brake release cable from the pedal assembly.
    7. Fig 1: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  7. Note the routing of the cable as you remove the park brake release handle assembly from the vehicle.
scientia non olet · About LEMON Manuals