LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1004 (Parking Brake System) >> Repair Instructions >> Park Brake Release Handle Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake release handle assembly to the vehicle. Install the cable using the same routing as the original cable.
  2. Install the park brake release cable to the pedal assembly.
  3. Install the park brake release cable housing to the pedal assembly.
  4. Install the MID-bussed electrical center to the bracket.
  5. Install the park brake release lever handle to the knee bolster.
    6. Fig 1: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the park brake release lever mounting bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
scientia non olet · About LEMON Manuals