LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1004 (Parking Brake System) >> Repair Instructions >> Park Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the front park brake cable to the park brake lever.
    2. Fig 1: Front Brake Cable & Park Brake Lever
    GM913310Courtesy of GENERAL MOTORS CORP.
  2. Install the park brake lever.
    3. Fig 2: Park Brake Lever & Mounting Nuts
    GM376012Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the park brake lever mounting nuts.

    Tighten:  Tighten the nuts to 25 N.m (18 lb ft).

  4. Connect the park brake release cable and housing to the park brake lever.
    5. Fig 3: View Of Park Brake Release Lever Handle & Bolt
    GM376009Courtesy of GENERAL MOTORS CORP.
  5. Connect the park brake warning lamp connector.
    6. Fig 4: Park Brake Warning Lamp Switch Electrical Connector
    GM606395Courtesy of GENERAL MOTORS CORP.
  6. Install the MID-bussed electrical center to the bracket.
  7. Install the left side hinge pillar panel. Refer to Trim Panel Replacement - Hinge Pillar in Interior Trim.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  9. For 15 series vehicles, install the park brake cable to the equalizer by pulling down on the park brake cable in front of the equalizer then installing the cable to the equalizer bar.
    10. Fig 5: Equalizer Bar & Park Brake Cable - Rear
    GM791349Courtesy of GENERAL MOTORS CORP.
  10. For 25/35 series vehicles, enable the park brake cable automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster .
  11. Remove the safety stands and lower the vehicle.
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
scientia non olet · About LEMON Manuals