Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new brake cable (2) into the rear brake cable mounting bracket (3) by pushing the cable into place until the locking tabs (1) snap into place.
- Install the park brake cable to the lever.
- Install the rear park brake cable bracket bolt.
Tighten: Tighten the rear park brake cable bracket bolt to 61 N.m (45 lb ft).
- Install the park brake cable to the differential clip.
- Install the park brake cable bolt to the rear axle clip.
Tighten: Tighten the park brake cable bolt to 25 N.m (18 lb ft).
- Install the park brake cable taking care to correctly route the cable though the guides and the body mounts.
- Install the park brake cable into the mounting bracket until the locking tabs snap into place.
- Pull down on the park brake cable in front of the equalizer and install the left park brake cable to the equalizer bar.
- Remove the safety stands.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice in Cautions and Notices.