LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1004 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Intermediate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. For all 15 series vehicles, relieve the tension from the park brake cable by pulling down on the park brake cable in front of the equalizer then removing the cables from the equalizer bar.
    Fig 1: Equalizer Bar & Park Brake Cable - Rear
    GM791349Courtesy of GENERAL MOTORS CORP.
  4. For 25/35 series vehicles, disable the park brake cable automatic adjuster. Refer to Disabling the Park Brake Cable Automatic Adjuster .
  5. For 25/35 series vehicles, disconnect the intermediate cable from the rear park brake cable.
  6. Disconnect the intermediate cable from the front cable.
  7. Fig 2: View Of Park Brake Cable - Front/Intermediate
    GM363830Courtesy of GENERAL MOTORS CORP.
  8. Remove the intermediate cable from the vehicle.