LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1004 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable.
  2. Snap the retainer tabs into the body mount.
  3. Connect the front cable to the intermediate cable.
    4. Fig 1: View Of Park Brake Cable - Front/Intermediate
    GM363830Courtesy of GENERAL MOTORS CORP.
  4. Route the cable in through the floor pan and engage the grommet.
    5. Fig 2: Frong Park Brake Cable Grommet
    GM376010Courtesy of GENERAL MOTORS CORP.
  5. Remove the safety stands.
  6. Lower the vehicle.
  7. Roll the carpet into place.
  8. Install the park brake pedal. Refer to Park Brake Pedal Assembly Replacement .
  9. Adjust the park brake system. Refer to Park Brake Adjustment .
scientia non olet · About LEMON Manuals