LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1004 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Mounting Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable support bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the cable support bracket nuts.

    Tighten:  Tighten the support bracket nuts to 85 N.m (64 lb ft).

    3. Fig 1: Park Brake Cable Support Bracket
    GM363840Courtesy of GENERAL MOTORS CORP.
  3. Install the rear cables to the mounting bracket by inserting the cable till all the retaining tabs snap into place.
    4. Fig 2: Park Brake Cable & Mounting Bracket
    GM363847Courtesy of GENERAL MOTORS CORP.
  4. Connect the rear cables to the equalizer.
  5. Tighten the nut to the intermediate cable at the equalizer.

    Tighten:  Tighten the nut to 3.5 N.m (31 lb in).

  6. Remove the safety stands.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals