Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.

For 25/35 series vehicles, connect the cable at the equalizer.
For 25/35 series vehicles, enable the park brake cable automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster .
For the 15 series vehicles, connect the rear park brake cables to the equalizer.

Fig 1: View Of Park Brake Cable & Equalizer

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

For the 15 series vehicles, install the nut to the threaded end of the intermediate cable.
Tighten: Tighten the nut to 3.5 N.m (31 lb in).

Fig 2: Park Brake Cable & Equalizer (15 Series)

Courtesy of GENERAL MOTORS CORP.

Remove the safety stands and lower the vehicle.
Adjust the park brake system. Refer to Park Brake Adjustment .