LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1002 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the windshield washer hose to the nozzle under the center air inlet grille panel.
    2. Fig 1: Air Inlet Grille Panel & Clips
    GM348546Courtesy of GENERAL MOTORS CORP.
  2. Position the air inlet grille panel to the vehicle and attach the clips to the edges of the center air inlet grille panel.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the sheet metal screws on each end of the air inlet grille panel.

    Tighten:  Tighten the sheet metal screws to 2 N.m (18 lb in).

  4. Align the outboard air inlet grille panel clips and press down in order to install.
    5. Fig 2: View Of Cowl Vent Grille Panel Outboard Section
    GM334315Courtesy of GENERAL MOTORS CORP.
  5. Install the wiper arms. Refer to Wiper Arm Replacement in Wipers/Washer Systems.
scientia non olet · About LEMON Manuals