Retained Accessory Power (RAP) Inoperative

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Yes	No
Schematic Reference: Data Link Connector (DLC) Schematics in Data Link Communications Connector End View Reference: Master Electrical Component List in Wiring Systems
1	Did you perform the Diagnostic System Check - Retained Accessory Power?	Go to Step 2	Go to Diagnostic Starting Point - Retained Accessory Power
2	Install a scan tool. Select diagnostic circuit check and then class 2 power mode. Close all the doors. Turn ON the ignition, with the engine OFF. Wait 5 seconds then turn the ignition OFF. Wait the time-out for retained accessory power (RAP). Did the scan tool display the RAP power mode, then time-out and display Off-Awake power mode?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 5	Go to Step 4
4	IMPORTANT: Perform the module setup procedure if required. Replace the BCM. Refer to Control Module References in Body Control System.Did you complete the procedure?	Go to Step 5	-
5	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2