LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Wheel Alignment Specifications & Adjustment Procedures) >> Ride Height >> Checking Procedure >> "G" Series (Rear)

"G" Series (Rear)

WARNING: This page does not describe the selected car, but rather 47 other vehicles, including the 2001 Pontiac Montana, 2001 Pontiac Aztek, 2001 Oldsmobile Silhouette, 2001 Oldsmobile Bravada, and 2001 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lift front bumper about 1.5" (38 mm). Gently remove hands and allow vehicle to settle on its own. Do this 2 more times. Measure ride height ("D") on right side of vehicle. See Figure and Figure .
  2. Push front bumper down about 1.5" (38 mm). Gently remove hands and allow vehicle to rise on its own. Do this 2 more times. Measure ride height on right side of vehicle again. Average measurements.
  3. Repeat steps  1 and  2 on left side of vehicle. Compare right and left side measurements. Rear trim height difference should not exceed 0.5" (13 mm) from side-to-side (left to right). If ride height is not as specified, repair or replace suspension components as necessary. If ride height is okay, align wheels. See WHEEL ALIGNMENT PROCEDURES  .
scientia non olet · About LEMON Manuals