LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Brake Rotor >> Installation

Rear Brake Rotor: Installation

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install hub and rotor assembly. Install washer and adjusting nut. Using Wheel Bearing Nut Wrench (J-2222-C), tighten adjusting nut to 50 ft. lbs. (68 N.m) while turning hub and rotor assembly.
  2. Back off adjusting nut and tighten to 30-40 ft. lbs. (41-54 N.m) while turning hub and rotor assembly. Back off adjusting nut 135-150 degrees. Install lock washer and lock nut finger tight. Bend lock washer tab over adjusting nut flat at a minimum angle of 30 degrees.
  3. Tighten lock nut to 65 ft. lbs. (88 N.m) minimum. Bend lock washer tab over lock nut flat at a minimum angle of 60 degrees. To install remaining components, reverse removal procedure.
Fig 1: Exploded View Of Rear Axle Shaft, Hub & Rotor Assembly (Full-Floating Axle)
G95D27105Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals