LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Front Brake Caliper >> Installation (Sliding Caliper)

Installation (Sliding Caliper)

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using wire brush, clean corrosion from machined ways on caliper and caliper mount. Apply silicone grease to these surfaces. Install inner pad and anti-rattle spring on caliper mount. See Figure. Install outer pad in caliper. Place caliper on caliper mount.
  2. Install caliper support key and spring. Install caliper support key bolt, ensuring bolt boss fits into circular cutout on caliper support key. Tighten bolt to 15 ft. lbs. (20 N.m).
  3. Connect brake hose to caliper and tighten hose bolt to specification. See TORQUE SPECIFICATIONS  table. Bleed brake system. See MANUAL BLEEDING  or PRESSURE BLEEDING  under BLEEDING BRAKE SYSTEM. Install wheel.
scientia non olet · About LEMON Manuals