Conditions For Running DTC

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0200, P0131, P0132, P0134, P0135, P0151, P0152, P0154, P0155, P0300, P0440, P0442, P0446, P0452, P0453, or P1441 are not set.
The Engine Coolant Temperature (ECT) is more than 135°F (57°C).
The engine run time is more than 160 seconds.
The Mass Air Flow (MAF) sensor is between 20-45 g/s.
The engine speed is between 1300-3000 RPM.
The Evaporative (EVAP) emissions purge solenoid command is more than 1 percent.
The Throttle Position (TP) is more than 5 percent.
The loop status is closed.
The ignition 1 signal is between 9-18 volts.
The fuel tank level remaining is more than 10 percent.
Intrusive tests are not in progress.
The scan tool output controls are not active.
The above conditions are met for 100 seconds.