Conditions For Running DTC

DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0131, P0132, P0134, P0135, P0151, P0152, P0154, P0155, P0200, P0300, P0440, P0442, P0446, P0452, P0453, or P1441 are not set.
The engine run time is more than 160 seconds.
The engine speed is between 1300-3000 RPM.
The Engine Coolant Temperature (ECT) sensor is more than 135°F (57°C).
The Mass Air Flow (MAF) sensor is between 18-45 g/s.
The loop status is Closed.
The Throttle Position (TP) sensor is more than 5 percent.
The fuel tank level remaining is more than 10 percent.
The ignition 1 signal voltage is between 9-18 volts.
The scan tool output controls are not active.
The intrusive tests are not in progress.
The Evaporative (EVAP) emissions purge solenoid command is more than 1 percent.
The above conditions are met for 100 seconds.