LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Ignition Systems >> Crankshaft Position Sensor >> Removal (4.3L)

Removal (4.3L)

  1. Turn ignition off. Raise and support vehicle. Remove steering linkage shield mounting bolts and steering linkage shield (if equipped).
  2. Disconnect Crankshaft Position (CKP) sensor harness connector. CKP sensor harness connector is located on front of engine, behind crankshaft pulley. See Fig 1. Remove CKP sensor mounting bolt and CKP sensor.
Fig 1: Locating Crankshaft Position Sensor (4.3L)
G00028213Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals