Removal & Installation (Blazer & Jimmy Canadian - 4-Door)

1. Raise and support vehicle. Lower the spare tire (models with an underbody mounted spare). Locate EVAP canister vent solenoid, under center rear of vehicle, mounted to crossmember. See Fig 1.
2. Disconnect EVAP canister vent solenoid electrical connector. Disconnect vent hose at EVAP canister vent solenoid. Bend back the tang on the EVAP canister vent solenoid mounting bracket. Remove the EVAP canister vent solenoid from the mounting bracket. To install, reverse removal procedure.

Fig 1: Removing/Installing EVAP Canister Vent Solenoid (Blazer & Jimmy Canadian - 4-Door)

Courtesy of GENERAL MOTORS CORP.