Assembling Components

Assemble components using only the sealant (or equivalent) that is specified in the service procedure.
Sealing surfaces must be clean and free of debris or oil.
Specific components such as crankshaft oil seals or valve stem oil seals may require lubrication during assembly.
Components requiring lubrication will be identified in the service procedure.
Apply only the amount of sealant specified in the service procedure to a component.
Do not allow the sealant to enter into any blind threaded holes, as the sealant may prevent the fastener from clamping properly or cause component damage when tightened.
Important: Do not overtighten the fasteners.
Tighten the fasteners to the proper specifications.